What is the Oil Filter Housing all about?

Oil filter housing allows engine oil to flow through the oil filter efficiently and ultimately reach vital engine parts.

Keep in mind:

Oil filter houses are in nearly every engine and they’re responsible for securing the oil filter in place.
Oil filter houses are responsible for keeping clean oil circulating around the engine.
They’re affected by the oil that runs through them, so if you allow your oil to stay dirty for a long time it can contaminate oil filter houses.
How it’s done:

Release fuel system pressure
Drain the cooling system
Remove the lower intake manifold
Disconnect the oil temperature sensor and oil pressure sensor electrical connectors
Remove five bolts and lift the oil filter housing
Install the coolant hose to the filter housing
Tighten the housing bolts and connect the oil pressure sensor electrical connector
Connect the oil temperature sensor electrical connector
Install the lower intake manifold
Fill the cooling system
Our recommendation:

Avoid using a spin-on oil filter because it can lead to a lot of parts that will require recycling. With materials like metal and specialized silicone rubber, which are impervious to the elements, it would take decades for it to break down if it was thrown into a landfill.

What common symptoms indicate you may need to replace the Oil Filter Housing?

Oil change light is on
Dripping oil from under the car
Low oil pressure
How important is this service?

The oil filter housing is an important service to ensure your vehicle’s engine is lubricated and that oil is reaching all parts of your engine to avoid friction and part damages.

READ  Experienced Airbnb Manager/Caretaker in Joshua Tree, California - (Joshua Tree, CA)